Free shipping above $179
Textured Foot (set of 3)








1/8
Textured Foot (set of 3)
$14.52$16.1410% off
The Textured Foot (set of 3) brings together three of our foot makers: Heart, Daisy, and Rosette. Each one stamps a clean, finished foot with a raised design onto the base of your piece in a single press. Drape your slab over a mold, dust the clay lightly with cornflour so it will not stick, then center the foot maker and push it firmly into the clay. Swivel it gently up, down, left and right, wiggling a little so every edge releases, then slowly lift it away, with no sharp pulls. A quick way to give every pot a finished foot and a signature maker's mark. Part of the Foot Makers collection.
Read moreThe Textured Foot (set of 3) brings together three of our foot makers: Heart, Daisy, and Rosette. Each one stamps a clean, finished foot with a raised design onto the base of your piece in a single press. Drape your slab over a mold, dust the clay lightly with cornflour so it will not stick, then center the foot maker and push it firmly into the clay. Swivel it gently up, down, left and right, wiggling a little so every edge releases, then slowly lift it away, with no sharp pulls. A quick way to give every pot a finished foot and a signature maker's mark. Part of the Foot Makers collection.
Read moreSize
Small1.6 × 1.6 inSizes vary per foot maker
Medium2.4 × 2.4 inSizes vary per foot maker
Large3.1 × 3.1 inSizes vary per foot maker
Material
Plant-based Plastic
Delivery
Ships in
7 days
Available across United States
What's in this set
· 3 itemsBought separately these come to $16.14. The set saves you $1.62.
Frequently bought together
Tap any item to configure and add it to your cart.
Customers also bought
Customers who viewed this also viewed
More in Sets
Best sellers in Foot Makers
Use the foot maker anywhere

Press a Foot in One GoLine the foot maker up on the base and press. You get a clean, even foot ring in seconds, without trimming it on the wheel.

Matching SetsEvery piece gets the same foot at the same depth, so bowls and plates in a set sit level and read as one family.

Handbuilt BasesGive slab and pinch pieces a proper lifted foot. The base clears the table, so glaze runs stay off your shelf.
How to use
Work at Soft Leather HardPress the foot once the piece is soft leather hard. Softer clay slumps under the tool and wetter walls distort when you turn the piece over.
Line It Up FirstSet the foot maker down on the base and check it is centred before you press. Lift and reposition rather than sliding it, which smears the clay.
Press Straight DownCenter the foot maker on the base and press straight down with firm, even pressure. Keeping that steady downward pressure through the center, gently rock the tool in every direction to release the edges, then lift it straight up. Go easy on the rocking, too much widens the ring and leaves an uneven edge.
Tidy the EdgeRun a damp sponge or a rib around the ring to soften the cut edge. It stops the foot chipping later and gives a cleaner glaze line.
Clean and Store DryWash off clay with water and a soft brush, then dry fully before storing. Keep foot makers out of direct sun and away from heat, which can soften plant-based plastic over time.






























